![]() ![]() Ram stroke 18" (458 mm) with 4 rates of feed that gave strokes of: 17, 27, 52 and 98 per minute. Fitted as part of the standard equipment, the swivel-base machine vice had a jaw-open capacity of 7.5" (190 mm). The table had a top surface of 14" x 10" (355 x 254 mm) with a longitudinal traverse of 18.25" (463 mm) and 4 rates of cross-feed that ranged, per cut, from 0.0104" to 0.0417" (0.26 to 1.06 mm).Īble to be swivelled through 90° each side of upright, the tool slide had 4.25" (108 mm) of travel and could take cutters up to 11/16" x 1 1/4 " (17.5 mm x 32 mm). Ram stroke 14" (356 mm) with 4 rates of feed giving strokes per minute of: 18, 30 57 and 109. An identical range was sold badged as the Elliott 4S and 18S and 24S - also with strokes of 14", 18" and 24" The Alba 2S, 4S and 6S - machines easily recognised by the massive circular housing on the drive side of their main bodies. #Elliott shaper manual professionalThis model, together with the Elliot 10M, are the most easily-found and effective shapers for use in a home or light-duty professional workshop The Alba 1A as it was by the late 1940s with a full-frame stand that enabled the fitting of a sliding support bar under the front of the box. The machine's box table could be swivelled and featured two T slotted and one V-grooved sideĪbove and below: the 10-inch stroke Alba 1A as sold during the 1930s. (The clutch lever can be seen laying horizontally along the body of the machine and the two-speed gear was selected by moving in and out the black knob immediately above the motor) Automatic cross feed (with a safety over-run device) was fitted as standard and a vertical feed (also with over-load protection on later models) available as an option. Four speeds were available the rear-mounted motor had a double-step V pulley which drove a two-speed gear train and clutch unit. It was popular in both training and production workshops and many thousands are still in use. ![]() This extremely well-made and finished shaper was a development of the "Alba 1A" (see below). Elliott also badged other makes of shaper, including those by Invicta. Sold by Alba they carried model designations of 2S, 4S and 6S and, when marketed by Elliott, as the 4S and 18S and 24S (this model is shown towards the bottom of the page). Other models in the range included much larger ones with ram strokes of 14, 18 and 24 inches - these models being easily recognised by a massive circular housing on the drive side of the main body. Richard SmithĪlba shapers were made from the 1930s until the 1970s, the smallest model in the range being the 10-inch stroke 1A - a machine that was to become the well-known and very successful Elliott 10M, a machine sold widely to schools and colleges in the UK. #Elliott shaper manual manualsMachine Tool Manuals Catalogues Belts Books AccessoriesĪ Manual & Parts List is available for the 10M shaper and the largerĪlba/Elliott types including the 14", 18" and 24" S-TypesĮxperiment to determine extent of HydrogenĮmbrittlement in a weld by Dr. #Elliott shaper manual archiveEmail: t Machine Tool Archive Machine-tools Sal e & Wanted ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |